Ben Robertson
08-31-2008, 12:28 PM
Hello all,
I am just about to purchase an RS400 RGB projector from Laser world and am interested to see if any one has had exposure to them (Good or Bad). Estimated cost US $3000 landed in Australia
Any first hand advice on the Laserworld projector build quality and operation would be greatly appreicated.
I have learnt the hard way that the Chines stuff just dosnt cut the mustard, with 3 scanner sets failing with in 6 months on a 500 MW TTL RGB unit as a cost of US $1600 dollar unit from ( The TTL Diodes on these will probably be put into a YAG bed, as there seem no way to fit higher quality scanners on to the old existing box) I am starting of in the industry and as im footing the bills for my own mistakes im keen to avoid them if possible.
I am just about to purchase an RS400 RGB projector from Laser world and am interested to see if any one has had exposure to them (Good or Bad). Estimated cost US $3000 landed in Australia
Any first hand advice on the Laserworld projector build quality and operation would be greatly appreicated.
I have learnt the hard way that the Chines stuff just dosnt cut the mustard, with 3 scanner sets failing with in 6 months on a 500 MW TTL RGB unit as a cost of US $1600 dollar unit from ( The TTL Diodes on these will probably be put into a YAG bed, as there seem no way to fit higher quality scanners on to the old existing box) I am starting of in the industry and as im footing the bills for my own mistakes im keen to avoid them if possible.